How To Start Up Your Pool For The First Time
Brushing your pool finish at least twice a day is one of the best things you can do to maintain the gorgeous appearance of a pool finish. Before first filling a pool or adding substantial amounts of fresh water to the pool, either test the water using a good quality test kit or have it tested for ph, total alkalinity,.
Alkalinity adjusting chemicals for pool start up.
How to start up your pool for the first time. Switch the hose on and fill the pool until the water level reaches the middle of the entrance to the weir. Remove your pump lid, clean out the motor basket and make sure the pump has enough water for prime. Brush thoroughly twice per day to remove all plaster dust.
If you can split up the times, great! With a garden hose, fill the pump basket and then tighten the lid back on top of the housing. It's best to test your pool's water in several spots a couple of feet below the surface of the water.
(the pump reservoir only needs to be about 3/4 of the way full to prime). It’s almost time to start up your pool. Fill it slowly so you can make sure the water is seeping into the pump lines.
If it exceeds 0.2 ppm, it’s time to shock your pool. The combined chlorine level, or the amount of used up chlorine, should remain under 0.2 ppm. Then you must let your pump run for ½ a day to let the new water circulate with the old.
Never start the pump without water as this might damage the shaft seal. Use our handy dandy calculator to find out how many gallons of water your pool holds. New pool start up procedure.
If not, it won’t be a problem for it to run 24 hours a day. Running your pump and filter is very important to keep your pool clear and it’s better. Before you flip the switch, you'll want to remove the ice compensators from the skimmer put your skimmer baskets back and screw in the return jet eyeball fittings that direct water into your pool.
Your pool filter traps small particles to ensure clean and clear pool water. Find your pool's gallon capacity. Place the garden hose in the deep end of the pool, making sure to tie a cloth over the end of the hose to diffuse the water pressure.
Set the timer to run the pool at least 8 to 12 hours a day. The best thing to do is bring a water sample to your local pool professional for analysis. Test & balance your pool's chemical levels
If your pool gets a lot of use, shock it weekly. What you want here is for the lines from the skimmer to the pump to be full of water in order to create suction. Fill the pool until the water level is in the centre of the skimmer opening.
If your pool’s initial test shows an incorrect amount of alkalinity, then you need to add some chemicals to fix it. Empty the skimmers filter basket from debris. Add necessary water to get the level to halfway up your pool skimmer openings.
This will help you determine how much salt you're going to need. Fill the pumps filter basket housing with water. Firstly check a sample of the town water supply which had not been in to the pool, just straight from the tap.
Your first step when opening your pool is to test your water, because the results of your water tests will determine what pool startup chemicals you need to use. After that is done you can check your water balance and add your swimming pool chemicals. It doesn’t matter if it was too high or too low, chemicals are going to be needed.
Note the chlorine, ph & total alkalinity. Then add the peroxide directly to the pools. Shut the water off when it reaches the middle of the tile or skimmer throat.
Without daily pool filtration, or timely cleaning of the filter, particulate matter builds up. The following procedure should be used whenever a pool is being filled for the first time, refilled following maintenance or other major repair, or when restarting the pool for the swimming season. The first step regardless of your startup situation is knowing the gallon capacity of your swimming pool.
You should get yourself a good quality test kit or test strips before your pool is filled. Most pool stores will test your water for free if you bring in a water sample.
0 Response to "How To Start Up Your Pool For The First Time"
Post a Comment